Quantification of tripdiolide in human whole blood by liquid chromatography coupled with atmospheric pressure chemical ionization tandem mass spectrometry

A liquid chromatographic-tandem mass spectrometric (LC-MS/MS) assay was developed and validated to determine tripdiolide in human whole blood using dexamethasone acetate as an internal standard (I.S.). Liquid-liquid extraction with ethyl acetate was used to isolate them from the biological matrix. Detection was performed on a mass spectrometer coupled with a negative atmospheric pressure chemical ionization (APCI) in the multiple-reaction monitoring (MRM) mode. The calibration curve was linear (r² = 0.9973) in the concentration range of 0.5-100.0 ng/mL in human whole blood with a lower limit of quantification of 0.5 ng/mL. Intra-day and inter-day relative standard deviations (R.S.D.s) were less than 7.0 and 10.1%, respectively. Extraction recoveries of tripdiolide ranged from 80.5 to 90.1%. This assay can be used to determine trace tripdiolide in human whole blood.     

Cyclic Voltammetry in a Perfluorocarbon Emulsion Blood Substitute

Cyclic voltammetry in a perfluorocarbon emulsion based blood substitute (PEBS) was evaluated. The intent was to determine how PEBS affects the voltammetry of four representative electroactive compounds: potassium ferricyanide, ruthenium(II) trisbipyridine (rutris), hydroquinone, and 2,6‐dichloroindophenol (DCIP). Voltammograms in 0–20% PEBS‐Tris buffer mixtures are affected by PEBS, but reasonably well‐defined voltammograms are obtained in as much as 20% v/v. This report also shows that PEBS has only a small effect on amperometric detection of the reaction between DCIP and nicotinamide adenine dinucleotide (NADH), which has importance in clinical homogeneous immunoassays. Results support continued exploration of voltammetry/amperometry for quantitative analysis in this medium.     

Pressurized wet digestion in open vessels

The High Pressure Asher (HPA-S) was adapted with a Teflon liner for pressurized wet digestion in open vessels. The autoclave was partly filled with water containing 5% (vol/vol) hydrogen peroxide. The digestion vessels dipped partly into the water or were arranged on top of the water by means of a special rack made of titanium or PTFE-coated stainless steel. The HPA-S was closed and pressurized with nitrogen up to 100 bars. The maximum digestion temperature was 250 °C for PFA vessels and 270 °C for quartz vessels. Digestion vessels made of quartz or PFA-Teflon with volumes between 1.5 mL (auto sampler cups) and 50 mL were tested. The maximum sample amount for quartz vessels was 0.5–1.5 g and for PFA vessels 0.2–0.5 g, depending on the material. Higher sample intake may lead to fast reactions with losses of digestion solution. The samples were digested with 5 mL HNO₃ or with 2 mL HNO₃+6 mL H₂O+2 mL H₂O₂. The total digestion time was 90–120 min and 30 min for cooling down to room temperature. Auto sampler cups made of PFA were used as digestion vessels for GFAAS. Sample material (50 mg) was digested with 0.2 mL HNO₃+0.5 mL H₂O+0.2 mL H₂O₂. The analytical data of nine certified reference materials are also within the confidential intervals for volatile elements like mercury, selenium and arsenic. No cross contamination between the digestion vessels could be observed. Due to the high gas pressure, the diffusion rate of volatile species is low and losses of elements by volatilisation could be observed only with diluted nitric acid and vessels with large cross section. In addition, cocoa, walnuts, nicotinic acid, pumpkin seeds, lubrication oil, straw, polyethylene and coal were digested and the TOC values measured. The residual carbon content came to 0.2–10% depending on the sample matrix and amount.     

MoS2纳米管包覆单壁碳纳米管束的制备

MoS₂ nanotube coated SWNT (Single wall carbon nanotube) bundles have been successfully prepared by adsorbing (NH₄)₂MoS₄ onto SWNT bundles and subsequent heat treatment under H₂ at 900 ℃ in a tube furnace. The morphologies, structure and composition of the as-prepared sample were investigated by XRD, SEM, HRTEM coupled with EDS. The formation mechanism has also been preliminarily discussed.     

The versatility of salicylaldehyde thiosemicarbazone in the determination of copper in blood using adsorptive stripping voltammetry

The adsorptive cathodic stripping voltammetry technique (AdCSV) is used to determine copper(II) using salicylaldehyde thiosemicarbazone (N, S- donor) as a complexing agent on hanging mercury drop electrode at pH 9.3. Variable factors affecting the response, i.e. the concentration of ligand, pH, adsorption potential and adsorption time are assessed and optimized. The adsorbed complex of copper(II) and salicylaldehyde thiosemicarbazone gives a well defined cathodic stripping peak current at −0.35 V, which has been used for the determination of copper in the concentration range of 7.85 × 10⁻⁹ to 8.00 × 10⁻⁶ M with accumulation time of 360 s at −0.1 V versus Ag/AgCl. This technique has been applied for the determination of copper in various digested samples of whole blood at trace levels.     

Sensitive Voltammetric Response of p‐Nitroaniline on Single‐Wall Carbon Nanotube‐Ionic Liquid Gel Modified Glassy Carbon Electrodes

An ionic liquid (i.e., 1‐butyl‐3‐methylimidazolium hexafluorophosphate, BMIMPF₆)‐single‐walled carbon nanotube (SWNT) gel modified glassy carbon electrode (BMIMPF₆‐SWNT/GCE) is fabricated. At it the voltammetric behavior and determination of p‐nitroaniline (PNA) is explored. PNA can exhibit a sensitive cathodic peak at ?0.70 V (vs. SCE) in pH 7.0 phosphate buffer solution on the electrode, resulting from the irreversible reduction of PNA. Under the optimized conditions, the peak current is linear to PNA concentration over the range of 1.0×10^?8–7.0×10^?6 M, and the detection limit is 8.0×10^?9 M. The electrode can be regenerated by successive potential scan in a blank solution for about 5 times and exhibits good reproducibility. Meanwhile, the feasibility to determine other nitroaromatic compounds (NACs) with the modified electrode is also tested. It is found that the NACs studied (i.e., p‐nitroaniline, p‐nitrophenol, o‐nitrophenol, m‐nitrophenol, p‐nitrobenzoic acid, and nitrobenzene) can all cause sensitive cathodic peaks under the conditions, but their peak potentials and peak currents are different to some extent. Their peak currents and concentrations show linear relationships in concentration ranges with about 3 orders of magnitude. The detection limits are 8.0×10^?9 M for p‐nitroaniline, 2.0×10^?9 M for p‐nitrophenol, 5.0×10^?9 M for o‐nitrophenol, 5.0×10^?9 M for m‐nitrophenol, 2.0×10^?8 M for p‐nitrobenzoic acid and 8.0×10^?9 M for nitrobenzene respectively. The BMIMPF₆‐SWNT/GCE is applied to the determination of NACs in lake water.     

单壁碳纳米管的结构修饰

由于单壁碳纳米管具有独特的结构、电学及机械等性能，可望在许多新领域得 到应用，已引起广泛的关注。但由于单壁碳纳米管不溶于水和常见的有机溶剂，极 大地制约了其应用性能的研究。随着单壁碳纳米管制备技术的不断完善，其研究方 向已开始转向结构修饰及应用性能的研究。主要介绍近年来单壁碳纳米管结构修饰 方面的最新发展状况，重点讨论化学功能化及物理吸附。     

Preparation and Characterization of Three-dimensionally Ordered Crystalline Macroporous CeO2

Three-dimensional ordered macroporous (3DOM) materials are of great potential importance in catalysis, selective separation, sensor arrays and communications with optical band gaps1. Many results in the synthesis of 3DOM materials have been reported, such as closed-packed silica spheres or polystyrenes (PS) templating routes for silica2, metal oxides1-6 and metals7. Recently, poly(methyl methacrylate) (PMMA) colloidal crystal templates have been used to prepare 3DOM materials of metals8,…     

Practical and quality-control aspects of multi-element analysis with quadrupole ICP–MS with special attention to urine and whole blood

Two screening methods were developed for rapid analysis of a great number of urine and blood samples within the framework of an exposure check of the population after a firework explosion. A total of 56 elements was measured including major elements. Sample preparation consisted of simple dilution. Extensive quality controls were applied including element addition and the use of certified reference materials. Relevant results at levels similar to those found in the literature were obtained for Co, Ni, Cu, Zn, Sr, Cd, Sn, Sb, Ba, Tl, and Pb in urine and for the same elements except Ni, Sn, Sb, and Ba in blood. However, quadrupole ICP–MS has limitations, mainly related to spectral interferences, for the analysis of urine and blood, and these cause higher detection limits. The general aspects discussed in the paper give it wider applicability than just for analysis of blood and urine—it can for example be used in environmental analysis.     

SYNTHETIC STUDIES ON BLOOD COMPATIBLE BIOMATERIALS 13:A NOVEL SEGMENTED POLYURETHANE CONTAINING PHOSPHORYLCHOLINE STRUCTURE:SYNTHESIS,CHARACTERIZATION AND BLOOD COMPATIBILITY EVALUATION

A new phosphorylcholine, (6-hydroxy) hexyl-2-(trimethylammonio) ethyl phosphate (HTEP), was synthesized andcharasterized. Segmented polyurethane (SPU) containing phosphorylcholine structure was synthesized based ondiphenylmethane diisocyanate (MDI), soft segment polytetramethylene glycol (PTMG) and HTEP, with 1,4-butanediol (BD)as a chain extender. The existence of phosphorylcholine structure on the surface of SPU was revealed by attenuated totalreflectance Fourier transform infrard spectroscopy (ATR-FTIR), X-ray photoelectron spectroscopy (XPS) and water contactangle measurements. The blood compatibilities of the polymers were evaluated by hemolytic testing and a platelet-richplasma (PRP) adhesion experiment, which was viewed by scanning electron microscopy (SEM) with polyurethane as areference. The novel segmented polyurethane containing phosphorylcholine structure showed improved blood compatibility.